CUTTER CREATIONS
Pre Cut, Pre Positioned, Fusible Fabric Designs
One significant benefit of using our cutting service or purchasing a pre-cut design from us,
is the fact the cut design comes "in tact" in it's final positioning form with a clear piece
over the top of it. Peel the back protective covering off. The top clear piece allows
you to "see through" and place your pre-cut design exactly where you want it all
in one quick second. You then iron on top of the clear piece which releases the
pre-cut design to the background, then easily peel up the clear piece.
After which you continue to press/steam (seal) the pre-cut design
to the background, just like you would fuse any item
with Steam-A-Seam type application on it.
Step by step instructions for using the pre-cut fabric designs:
First: peel off the back piece of vinyl/plastic/paper.
Second: place the design in tact unto background fabric.
Third: iron light to medium heat on the top piece of plastic the design is adhered too
Fourth: pull up the top piece of plastic - leaving the design in position
Fifth: iron/steam down the design to your background fabric
*** Click on the categories below to view our cuts. ***
Our PRE CUT, PRE POSITIONED FUSIBLE Fabric Designs
have gone through many steps, all saving you time and money.
Top quality batik fabrics are used, starting with being washed
and dried and then Steam -A-Seam II is applied. Next the design
is cut and then weeded (all the pieces not staying in the design
are pulled out - one at a time). After which the final fabric
design is then pre positioned into the carrier.
Our pre cut fusible designs are different than others
you may have seen or purchased. They are not laser
or die cut and are not mass produced. We create
and package each cut/design individually.
Latest releases are shown here and also under the New - Latest Release Category:
.jpg)
| 
Home of Lickity Stitch Designs 
